Hi,

The start and end ports range should be set to the same (like 80-80) in TCP.
You should for example redirect this port 80 (public port range) to the local port you selected in Enigma-TV ... this on the IP adress of your PC where Enigma-TV runs on.
Do the same for the stream port range (like 8085 - 8085)

Best regards,

What I tried so far is to create service in services section. I gave it name "enigma" and set it to Type: TCP
Start Port: 80
Finish Port:85
In my enigma TV settings 80 is public web port and 85 is Local web port.
My public stream port is 8080 and Local stream port 8085

After creating service I went to Security and firewall rules and tried to set enigma service in IPV6 Firewall (there is no IPV4 settings option). I add enigma to Outbound services to ALLOW always and I did the same in Inbound services when I tried to put in "Send to LAN Server:" section my local stream IP taken from enigma TV settings. This didn't work and I start playing with different settings which I told might be appropriate but no success.

I tried to upload to my post and screens from my router settings and my Enigma TV settings but looks like was unsuccessful

Hi,
I am having problem forwarding ports on my sky router (Manufacturer Sky Model SR102, Firmware Version 2.88.1086.R)
Streaming TV over LAN is OK but I cannot open public web interface.
I watched your instruction videos but I cannot find the way how to do it on my router.